Waeco COOLFREEZE CDF 11, Руководство по эксплуатации

Страница: 35 / 252

EN
CoolFreeze CDF11 Troubleshooting
35
8 Troubleshooting
9 Disposal
➤
Place the packaging material in the appropriate recycling waste bins
wherever possible.
M
If you wish to finally dispose of the product, ask your local recycling
centre or specialist dealer for details about how to do this in
accordance with the applicable disposal regulations.
Fault Possible cause Suggested remedy
Device does not function,
“POWER” LED does not
glow. There is no voltage
present in the 12/24 V
socket (cigarette
lighter) in your
vehicle. The ignition must be switched on in
most vehicles to apply current to the
cigarette lighter.
The device does not cool
(plug is inserted, “POWER”
LED is lit). Defective compressor. This can only be repaired by an author-
ised customer repair agent.
The device does not cool
(plug is inserted, “POWER”
LED flashes, the display is
blank). The voltage present in
the 12/24 V socket is
too low. Check the battery and charge if neces-
sary.
Check the wiring and connections.
When operating from the
12/24 V socket (cigarette
lighter):
The ignition is on and the
device is not working and
the “POWER” LED is not lit.
Pull the plug out of the
socket and make the follow-
ing checks. The cigarette lighter
socket is dirty. This
results in a poor elec-
trical contact. If the plug of your cooler becomes very
warm in the cigarette lighter socket,
either the lighter socket must be
cleaned or the plug has not been
assembled correctly.
The fuse of the
12/24 V plug has
blown. Replace the fuse (5 A) in the cigarette
lighter plug, see chapter “Replacing the
plug fuse (12/24 V)” on page 33.
The vehicle fuse has
blown. Replace the vehicle’s 12/24 V socket
fuse (usually 15 A). Please refer to
your vehicle’s operating manual.
“ERROR” LED flashes and
the display shows “ERR1”
or “ERR2”. Device is defective. This can only be repaired by an author-
ised customer repair agent.