Waeco CoolAir CA-800-DAF, Руководство по установке

Страница: 33 / 160

33
Installation CoolAir
6.3.1 Start and end configuration mode
The adjustable parameters can be altered in edit mode:
➤
With the system switched off, press the ON/OFF button (see fig. 10 on
page 6, Pos. 1) and hold it down for 2-4 seconds.
➤
Additionally press the operating mode button (see fig. 10 on page 6,
Pos. 4) within these 2-4 seconds.
➤
Let go of the ON/OFF button.
➤
Hold the operating mode button pressed until the LED compressor
flashes.
✓
You are now in configuration mode.
✓
The first digit of the display (see fig. 10 on page 6, Pos. 5) shows the
menu level and the second and third show the parameter which can
be set – for example,
1.17
for menu level 1 and a set value of 17 °C.
If you make no entry on the control panel for 60 seconds, the system quits
configuration mode and switches off.
➤
Press the ON/OFF button to quit configuration mode.
6.3.2 Menu level 1: Set temperature
The system always starts with a defined value for the room temperature.
This parameter can be configured between 17 and 30 °C:
➤
Start configuration mode (see chapter "Start and end configuration
mode" on page 33).
✓
The first digit of the display (see fig. 10 on page 6, Pos. 5) shows the
menu level and the second and third show the parameter which can
be set.
➤
Press the operating mode button (see fig. 10 on page 6, Pos. 4) to
change the parameter.
➤
Use the + or - buttons (see fig. 10 on page 6, Pos. 6 and 7) to select
the temperature (in °C) with which the system starts.
✓
The digits in the display flash until the parameter you enter is con-
firmed.
➤
Press the operating mode button (see fig. 10 on page 6, Pos. 4) to
confirm your entry.
✓
The set value is saved and is then used when the system is restarted.
✓
You are now in menu level 1 and can use the + and - buttons to switch
between menu levels.
CA-800-Install.book Seite 33 Mittwoch, 4. Juli 2007 3:05 15