Waeco CoolAir CA-800-DAF, Руководство по установке

Страница: 32 / 160

Installation CoolAir
32
6.2.7 Attach the cover frame
Tighten the screws carefully so that the cover frame is not damaged.
➤
Attach the cover frame (see fig. 5 on page 4, Pos. 5) with the four cy-
lindrical washers M7 (see fig. 5 on page 4, Pos. 6) to the
system.
6.3 Configuration of system software
Before you first start up the system, adapt the controls according to the in-
stallation conditions. This must be done by the person installing the sys-
tem.
In configuration mode, the following system software parameters must be
set on the control panel (see fig. 10 on page 6):
The configuration mode can also be called if the undervoltage protection
has switched off the system and there is only residual voltage.
Menu
level
Parameter Meaning Default
setting
1 Set temperature The system starts with the temper-
ature defined here.
20 °C
2 Low-voltage
cut-off The battery monitor switches the
system off at the defined voltage. ID number
4 = 23.5
Volt
3 Operating mode The system starts with the operat-
ing mode defined here.
0 =
Automatic
mode
4 Default
settings The parameters 1-3 can be
returned to the default settings. --
CA-800-Install.book Seite 32 Mittwoch, 4. Juli 2007 3:05 15