Wadia m330 media server, Руководство пользователя

Страница: 3 / 24

3
WARNING
DO NOT INGEST BATTERY, CHEMICAL BURN HAZARD
The remote control supplied with this product contains
a coin/button cell battery. If the coin/button cell battery
is swallowed, it can cause severe internal burns in just
2 hours and can lead to death. Keep new and used bat-
teries away from children. If the battery compartment
does not close securely, stop using the product and keep
it away from children. If you think batteries might have
been swallowed or placed inside of the body, seek im-
mediate medical attention.
1. Press the tab and lift up on the Battery Cover and
temporarily place it aside.
Refer to figures 2 and 3.
2. Refering to figure 6, press
on the bottom edge of the
battery to release the battery
from the molded battery
socket. Then remove the
battery from inside of the
Remote Control.
3. Reinstall the Battery Cover.
4. Store the battery in a cool dry place
for future use or dispose of the battery
in accordance with the local regula-
tions for lithium battery disposal. Bat-
teries should never be thrown away or
incinerated.
The Wadia m330 Remote Control uses a long life Lith-
ium Coin Cell type battery. The m330 may be sup-
plied with a battery depending on the country where
the m330 is purchased. When purchasing a battery for
use in the m330 refer to the following list:
Approved Lithium Batteries
Brand IEC No. ANSI/NEDA No.
Energizer CR2032
1
5004LC
1
Panasonic CR2032(PA/1B)
1
5004LC
1
1
CR Lithium Coin Cells contain Perchlorate Material - special handling
may apply. For additional information go to www.dtsc.ca.gov/hazaedous
waste/perchlorate/index.cfm
Access to the recessed battery compartment is located
on the Rear of the Remote Control. Refer to figure 1.
Perform the following steps to install the battery:
1. Press the tab towards the bottom edge of the
Remote Control and lift up on the Battery Cover
and temporarily place it aside. Refer to figures 2
and 3.
The life of the Lithium Battery used in the Wadia
Remote Control is dependent on the actual amount of
use. It is advisable to remove the battery from the Re-
mote Control when it is not to be used for an extended
period of time. This will help to extend battery life
and avoid possible damage to the Remote Control.
Perform the following steps to remove the battery
from the Remote Control:
2. Remove the CR2032 Battery from
its packaging.
3. Orient the battery so the + symbol
(engraved into one side of the bat-
tery) is facing up.
4. Refering to figures 4 and 5, insert
the battery into the socket. Make
sure the battery is touching both
contact points and is seated in the
socket.
5. Reinstall the Battery Cover.
6. The Remote Control is now ready for operation.
Battery Installation and Replacement
Battery Installation
Battery Removal
CAUTION:
Danger of explosion if the battery is in-
correctly installed. Only install one of the
approved Lithium Batteries listed below.
Figure 1
Battery
Compartment
Figure 2
TAB
Figure 3
LIFT
UP
Figure 5
CR
2032
CR2032
3V
Figure 4
CR
2032
Contact
Points
Battery
Figure 6