Wadia 931, Инструкция по эксплуатации и информации

Страница: 6 / 34

5
Quick Start
Unpacking and Placement
Unpack each of the cartons. Check each component for shipping damage and verify that the operating voltage
matches your local AC voltage. The Wadia 931 Digital Controller should be positioned near the source components,
the Wadia 921 Mono Decoding Computers should be placed near the amplifier or amplifiers.
Connections
Use the illustrations below and on the following page to connect the Wadia series 9 Decoding Computer
System. All rear-panel connectors are labeled. Input 1 on the 931 Digital Controller is configured for ClockLink.
If you are using a source component equipped with ClockLink, such as the Wadia 270 CD transport, connect it
to Input 1. Non-ClockLink sources should not be connected to ClockLink inputs. For instructions to configure
any input to turn ClockLink on or off, see
Configurations on page 22.
Level Setting
The Maximum Output Level can be set to match the sensitivity of your loudspeaker, room size, and listening
preference. The Wadia 921 Mono Decoding Computers come shipped from the factory with the output level set
at 2 volts RMS. For instruction on how to configure the output voltage see
Output Level Settings on page 13.
Operation
The Wadia 931 Digital Controller acts as the user-interface for the entire Wadia series 9 Decoding Computer
System and uses remote commands and operations that are similar to other Wadia products. For a full list of
instructions, refer to
Operations on page 16.
ClockLink Cable
Data Cable
Wadia 931 Digital Controller ClockLink-Equiped Digital Source