1 5 5 6 W o o d l a n d D r i v e . S a l i n e . M I 4 8 1 7 6 U S A
.
7 3 4 . 7 8 6 . 9 6 1 1
.
w w w . w a d i a . c o m
How do I dock and undock my iPod with the 170iTransport?
Connect your iPod once you have properly installed the appropriate dock insert. Gently slide the iPod down into
the dock insert. Make sure to align the connection on the bottom of the iPod with the multi-pin metal connector
located within the plastic dock insert. Do not force the iPod down into the dock insert or you may damage the
multi-pin connector and cause the Wadia 170iTransport to malfunction. To remove the iPod from the Wadia
170iTransport, grasp the iPod with a firm grip and pull upwards at the same angle of the iPod while docked.
How do I select the appropriate Dock Insert for my iPod?
The Wadia 170iTransport comes with several dock inserts that will allow it to accommodate the compatible
iPod models. First, you will want to determine which insert fits your iPod model. If there is already a dock insert
in the Wadia 170iTransport, you will want to remove it. This is accomplished by applying slight pressure with
your thumbs to the back of the insert while pushing up to release the dock insert. You can also try using your
finger nail to gently pull up on the notch at the back of the dock insert. Do not use excessive force to pry the
dock insert out of the 170iTransport. To install the new insert, make sure that the two (2) small slits in the inside
of the insert are facing the front of the Wadia 170iTransport. Place the dock insert over the multi-pin metal
connector and carefully click into place.
How do I connect the 170iTransport to AC power?
Check to make sure that the power cord shipped with your Wadia 170iTransport has been manufactured for
operation at your AC line voltage. Damage caused by improper operation is not covered by Wadia warranty.
If the included cable and wall termination is different from your AC outlet, contact your Wadia dealer.
How do I make the digital connection?
Connect your chosen cable from the S/PDIF Coaxial Digital Audio output on the Wadia 170iTransport to the
corresponding digital input on your Digital to Analog Convertor, Digital A/V Receiver or Digital Preamp/Processor.
How do I make the analog connection?
Connect your chosen cable from the Left and Right Line Level Audio outputs on the Wadia 170iTransport to the
corresponding analog input on your Television, Stereo Receiver or Other Analog Input Device. You will need to
use the mode button on the remote to activate the analog outputs on the 170iTransport.
How do I make a Component Video connection?
Connect your chosen cable from the Component Video output on the Wadia 170iTransport to the corresponding
Component Video input on your Television, A/V Receiver or Preamp Processor.
(The Wadia 170iTransport only
acts as a high-performance pass-thru for video signals. Picture performance is limited to the quality of the
material stored on the iPod. Some video adjustments may be necessary on your video display for maximum
video performance).
series 1
17 0 i T r a n s p o r t
