Wacker Neuson RTLx-SC3, Руководство оператора

Страница: 53 / 186

Operation
Emergency Shutdown Procedure 6.22
53
[en-US] | 09/2022 | 5100061327 | RTLx-SC3 | Operator’s Manual
Stopping the machine
1. Turn the vibration off by pressing the vibration off pushbutton (10) .
2. Place the throttle switch (1) in the low (turtle) position.
Note : The engine cannot be shut down using the throttle switch alone.
The throttle switch only changes the engine speed from high (rabbit) to
low (turtle).
3. Turn off the SmartControl™ SC-3 transmitter by pressing the red ON-
OFF pushbutton
(7) . The machine’s engine will shut down.
4. Rotate the starting key (2) counterclockwise to the OFF (O) position.
Note : The machine has a built-in shutoff timer. If the starting key is left
in the ON position when the engine is not running, the timer will shut off
the power to the control panel after one hour.
A parking brake is located in the rear drum. The brake is connected to the
hydraulic system through the brake valve of the control manifold. The brake
is spring activated and hydraulically disengaged. Hydraulic oil flow to the
brake is enabled as soon as the engine starts. Thus, when the engine is run-
ning, the brake is disengaged; when the engine is not running, the brake is
engaged.
6.22 Emergency Shutdown Procedure
wc_gr013391
1
Fig. 20: Transmitter power button
If a breakdown or accident occurs while the machine is operating:
1. Turn off the transmitter (1) to stop the engine and close the fuel valve.
2. Turn the roller key switch to the OFF position.
3. Return the machine to an upright position, if tipped over.
4. Contact rental yard or machine owner for further instructions.
6.23 NiMH Battery
The battery used to power the transmitter is a high capacity Nickel Metal Hy-
dride (NiMH) cell rated at 2000 mAh and is capable of accepting hundreds of
charging cycles. If the machine fails to operate for the full operating period,
even after the battery has been fully discharged and recharged, the battery
pack may need to be replaced.
Charging characteristics:
• Time to fully charge: 2 hours
• Full-charge operating time: 16 hours*
• Operating time after 1 hour charge: 8 hours*
• At temperatures below 0°C (32°F), charging is not possible
* Operating time decreases at severely cold temperatures.
6