Wacker Neuson G 25, Руководство оператора

Страница: 136 / 214

wc_tx003610gb_FM10.fm
136
Mobile Generator
Using Remote Start Capabilities
13.4 Preparing for Automatic/Remote Start-Up (Deep Sea)
Background In AUTO mode, the generator can be started remotely, either through a transfer
switch or some other type of remote start switch. AUTO mode is the normal setting
when using the generator as a stand-by power supply.
Procedure 1. Before putting using the AUTO mode,
perform a check of the auto start-up
circuit. To do so:
a. Attach a short jumper wire
(a)
(minimum 16-gauge insulated)
between the two terminals on the
remote run terminal block. The
jumper wire applies a ground to the
ECM to complete the start circuit.
b. Set the genset controller power
switch (b) to the ON position.
c. Press the AUTO mode button (c) .
d. Wait for the engine to crank, start,
and run. If the engine cranks, the remote start circuit is functioning.
e. Press the Stop/Reset “O” button (d) to stop the engine.
f. Remove the jumper wire from the remote run terminals after testing is
complete.
This procedure continues on the next page.
wc_gr011501
c
d
b
CAUTION
Possibility of accidental equipment start-up. If the contacts on any remote switch
linked to the generator are closed, the generator could start unexpectedly when the
AUTO mode button is pressed.
►
Before pressing the AUTO mode button, verify that the contacts on any remote
switch linked to the generator are OPEN.
20A 20A
50A 50A
0 0 5 6 3 2
AUS AUS
APAGADO APAGADO
ARRET ARRET
OFF OFF
REMOTE START REMOTE START
FERNSTART FERNSTART ARRANQUE REMOTO ARRANQUE REMOTO
DEMARRAGE A DEMARRAGE A
DISTANCE DISTANCE
START / LAUFEN START / LAUFEN ARRANQUE / MARCHA ARRANQUE / MARCHA
DEMARRER / MARCHE
DEMARRER / MARCHE
START / RUN START / RUN
a
wc_gr010206