Wacker Neuson BFS 614B, Руководство оператора

Страница: 21 / 36

BFS 614B Operation
wpm_tx001178gb.fm
19
3.7 Use of Cutting Blade
3.7.1 General application instructions for use of diamond cutting
blades:
3.7.1.1 Never use a diamond cutting blade of a diameter larger than
necessary to cut down to a certain depth.
3.7.1.2 Pull the blade out of the cut if it has stopped turning and
before restarting the engine. Check to see if the belt has
been tensioned sufficient if the cutting blade should get
stuck in the cut. Also check the tensioning screw and make
sure that it is correctly tightened.
3.7.1.3 Always cut a straight line. Mark the line clearly allowing the
operator to follow it easily without having to guide it from
one side to the other to come back to the line (do not cut
narrow curves).
3.7.1.4 Sufficient drive power is essential, therefore always cut with
engine at full throttle.
3.7.1.5 Never exceed the maximum turning speed (printed on
cutting blade).
3.7.1.6 Only use appropriate cutting blade for the material you are
going to cut. Wacker has an extensive selection of diamond
blades in different grades of qualities for you.
Diamond blades for asphalt are suited for:
Asphalt
Freshly mixed concrete (from 48 hours to 28 days old)
Sandstone
Sandy bricks
Floor toppings
Sandy limestone
Not suited for:
Set concrete
Hard bricks or paving setts
Concrete with exposed aggregates by washing
Natural stone
Diamond blades for concrete are suited for:
Set concrete (older than 28 days with reinforcements up to
maximum diameter of 6mm)
Not suited for:
Other kind of materials