Wachs Trav-L-Cutter E, Руководство пользователя

Страница: 22 / 68

Trav-L-Cutter
18 Part No. 02-MAN-01, Rev. A E.H. Wachs
M
achine
i
nsTallaTion
The Wachs Trav-L-Cutter (TLC) is shipped from the factory completely assembled and lubricat-
ed. It is only necessary to mount the machine, install the cutting wheel and connect the power
supply. Please observe the following warning stickers located on the TLC before proceeding to
operate machine.
Figure 4-1. Machine Installation
1.
Refer to the Section on Wheel Setting and Chain Lengths and determine the proper wheel
position for the size of pipe to be cut. If the wheel assemblies are not in the proper slots, the
eight 1/2” socket head cap screws (Part No. 90-090-17) shown in figure 1 should be removed
and the wheel assemblies taken from the carriage.Place the wheel assemblies in the proper
slots in the carriage. Make sure the protruding dowel pins (Part No. 90-076-20) are inserted
in the dowel pin holes. Replace the eight 1/2” socket head cap screws and tighten securely.
2.
Check and make sure the cutter spindle is in its uppermost position.
To raise the cutter spindle, loosen the thumbscrew (Part No. 90-059-04) and slide feed screw
lock (Part No. 02-008-00) back. With the aid of the socket wrench turn the feed screw in a
counter clockwise direction until the cutter spindle is raised to its highest position.
3.
From the Section on Wheel Setting and Chain Length, select the combination of chain
segments to make up the required length of chain.
Each segment of chain is marked for easy identification.