Wachs FF 206, Руководство пользователя

Страница: 32 / 90

SDB-103 Small Diameter Beveler and FF 206 Flange Facer
28 Part No. 16-MAN-01, Rev. 4-1109 E.H. Wachs
1.
Loosen and remove the collar nut and drawbar nut on
the standard mandrel.
2.
Turn the feed handle counter-clockwise until you can
remove the standard mandrel through the tool head of
the SDB 103.
3.
Remove the standard tool head from the SDB 103 by
taking out the 4 screws holding it.
4.
Remove the clamp legs on the small I.D. mandrel.
5.
Remove the drawbar nut and drawbar from the small
I.D. mandrel.
6.
Insert the small I.D. mandrel into the machine body.
Position the mandrel so that the keyways are aligned
with the keys in the machine, and turn the feed handle
clockwise to thread the mandrel into the feed nut.
7.
Slide the small I.D. rotating head over the end of the
mandrel. Install it on the machine body with the 4
screws.
8.
Measure the pipe I.D. and select the appropriate leg
set and o-ring to fit. Make sure to use the correct o-
ring for the leg set you are using. Refer to Table 2
below.
9.
Install the legs onto the drawbar chuck, using the o-
ring to hold them in place.
10.
Insert the small I.D. drawbar through the mandrel and
re-install the drawbar nut.
Installing the Independent Fitting Mandrel
If the pipe you are machining has an obstruction or bend
that does not allow enough room for the standard mandrel to
mount, use the independent fitting mandrel instead. Follow
this procedure to install the independent fitting mandrel.
NOTE
When returning
legs to their proper position
in the mandrel assembly,
the O ring that secures
them must be in the correct
position prior to reinstalling
the draw bar assembly. The
O ring will not slip over the
end of the draw bar once it
has been installed.
Table 2: Small-Diameter Mandrel Extension Legs
Leg Set I.D. Range O-Ring
16-067-00 0.875–1.125” (22.2–28.6 mm) 16-070-01
16-068-00 1.00–1.250” (25.4–31.8 mm) 16-070-02