DW Guillotine 208
38
Part No. 29-MAN-00, Rev. A
E.H. Wachs
The bow is fully retracted (up)
when it is stored. Mount the
machine with the bow
retracted.
2.
Set the machine on the pipe at the cutting location,
with the mounting baseplate on a supported section of
pipe. The cutting wire will be toward the fall-off end
of the pipe.
It is recommended that you
mount the saw so that the
controls are at an appropriate
height and convenient to
operate. The recommended
height for the controls is 2-5 ft
(0.6-1.5 m).
Figure 3-25. Set the machine on the pipe, with the
wire on the fall-off side of the cut.
It is recommended that you
support or set up a catch
device for the fall-off piece of
pipe. If you are cutting in-line
pipe, make sure the pipe is
supported on both sides of
the cut.
3.
Position the machine to align the wire at the required
cut line.
4.
Detach the mounting chain strap and wrap the chain
around the pipe.
5.
Pull the chain as snug as possible and insert the link
pins in the yoke on the chain clamp.
6.
Turn the clamping handle to tighten the chain. Clamp
the chain as tight as you can get it with the handle.
NOTE
CAUTION
NOTE
