dweLED
www.
dweLED
.com
Phone (800) 526.2588 • Fax (800) 526.2585
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone (516) 515.5000 • Fax (516) 515.5050
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone (800) 526.2588 • Fax (800) 526.2585
dweLED
retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
Feb 2019
INSTALLATION INSTRUCTION
S
911-Outdoor Wall Sconce
WS-W14911
Fig.1
PREPARATION
1. Shut off the power at the circuit breaker and remove existing fixture, including the crossbar.
2. Carefully unpack your new fixture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for
installation.
CONNECTING THE WIRES
(Fig. 2)
NOTE:
T
he side of the mounting back plate marked “GND” must face out.
5.
Connect the fixture’s input wires to junction box wires as shown
(
Fig. 2
). Make
sure that all wire connectors (A) are secure.
If your outlet box has a green or bare copper ground wire, connect the fixture’s ground wire to it. Otherwise, connect the
fixture’s ground wire directly to the back plate using the green screw provided. After wires are connected, tuck them carefully
inside the junction box.
MOUNTING THE FIXTURE/ CONNECTING THE WIRE
6. Secure the canopy to the mounting plate using the mounting screw (B) and the silicone gasket (C).
7. To prevent moisture from entering the outlet box and causing a short, use clear caulking (i.e. indoor/outdoor silicone sealant) to
outline the outside of fixture back plate where it meets the wall. Leave a space at a bottom to allow moisture to escape Fig.3.
Wire Connector
A
Junction Box Screw
Mounting Screw
B
Mounting Back
P
late
Junction Box
Silicon Gasket
C
Back Plate Dimensions
3.
Remove the mounting screw (B) and silicone gasket (C) from the fixture.
4.
Secure the mounting back plate to the junction box using
the screws provided with the
junction box.
Fig.
2
Wiring
Fixture Wires
House Wires
Black or
Black
Smooth
(Hot)
Fixture Wires
House Wires
White or
White
Ribbed
(Neutral)
Fixture Wires
House Wires
Bare wire
Green or Bare Copper
(Ground)
(Ground)
Junction Box
Caulking
Fig.
3
2
G0
