WABROTECH X51, Руководство по эксплуатации, Страница: 45 / 73

power/
The pump is not primed
Check for cracks or worn seals. If cracked or damaged,
the suction tube must be replaced
O-ring in pump is worn or damaged
Clean or replace the filter
Spray gun filter is clogged.
There is no paint or the suction tube is not
completely immersed in the paint
Replace the pump seal
Suction tube is not immersed in paint Make sure that the suction tube is submerged
Tighten the suction tube connection.
Unscrew the filter on the suction pipe. Use your finger
to gently move the ball on the bottom of the pump to
unlock it. If the ball moves and the unit still does not
pressurize, you can put a full glass of water directly
under the pump without a filter.
The pressure is set too low
Clean the filter
Clean the inlet valve. Make sure the ball seat is not
cut or worn and the ball is seated properly. Reinstall
the valve.
Loose suction pipe on inlet valve Clean the connection, check the seal and tighten
Unit did not prime when power valve was
turned
Pump runs but does not build up
pressure
Pump runs but does not build up
pressure
The spray nozzle is clogged
Suction set filter clogged
The main supply valve is worn or clogged
Prime the pump
Replace the sealing ring
Spray tip is too large or worn
Dip the suction tube into the paint, at least half a
bucket
The piston rod is worn or damaged. Clean or replace
Suction pipe leaking.
Pump runs but paint only drips or
squirts when gun is triggered Slowly turn the pressure control knob clockwise to
increase the pressure setting, which will turn on the
motor and build up pressure.
Unclog or replace the spray tip
Clean or replace gun filter
Replace the main spray valve
Worn pump packing
Inlet valve is leaking
Remove debris from the filter and make sure the
suction tube is submerged in the fluid
in the paint, at least halfway up the container
Stuck ball in the pump
The chiller filter is clogged
The unit starts but does not paint
Clean or replace the filter
The filter on the suction pipe is clogged
Clean the valve or replace with a new one
The suction pipe filter is clogged
Replace the nozzle
19
WABRO sc ul. Arki Boÿek 2A, 41-910 Bytom
NIP: PL6263032331 | Regon: 381911373
Wabrotech.pl
Machine Translated by Google
WABRO sc ul. Arki Bożka 2A, 41-910 Bytom
NIP: PL6263032331 | Regon: 381911373