WABECO D4000, Руководство по эксплуатации

Страница: 62 / 78

62
21. Coolant system (optional)
21.2 Mounting of the coolant system to the tool cabinet (optional)
To screw the lathe to the coolant system
proceed as follows:
1. Place the lathe carefully onto the panel (3) and align along the fixing holes.
2. Combine each hexagon socket screw with a washer.
3. Push the screws from below, through the fixing holes in the panel (3) and into the fixture thread on
the bed of the lathe and tighten using a size 13 combination wrench.
4. Place the lathe with the panel carefully onto the coolant system and align along the fixing holes.
5. Remove both inlay sheets out of the coolant system.
6. Combine each nut with a washer and screw from below the nuts onto out of the panel (3)
protruding threaded bolt.
7. Tighten the four nuts using a size 13 combination wrench.