WABECO CC-D6000 hs, Руководство по эксплуатации

Страница: 147 / 168

147
22. Coolant system (optional)
22.4 Filling the coolant system
A number of protective measures must be observed and taken in order to ensure that the handling of
coolant does not cause health risks or environmental loads.
■
Always observe the datasheet and the safety regulations of the coolant being used (can be
obtained from the supplier or manufacturer)
■
Observe all safety regulations set out in these operating instructions, in particular those that refer
to the safe handling of coolants.
■
In order to ensure reliable operation of the coolant pump, a minimum coolant filling level is
required in the coolant tank.
■
The capacity of the coolant system is approximately 19 litres.
■
The maximum filling level should be just below the shelf insert
■
The minimum filling level is approximately 15 mm below that.
■
To fill, remove the shelf insert and fill to the maximum filling level with a suitable coolant whilst
observing all safety regulations.
■
After filling, replace the shelf insert
22.5 Operating the coolant system without CNC control
The switch shown below is located on the mains cable of the coolant pump.
Switch position ( 0 )

Pump switched off
Switch position ( I )

Pump switched on
(Caution: Coolant flow is controlled with the coolant shut-off valve)