WABCO IVTM, Описание системы

Страница: 24 / 48

4
IVTM Components
24
4.5 Connecting tube
The wheel modules must be continuously connected to tires for sensing tire pres-
sures. Use WABCO pre-assembled PA tubes for this purpose. The connection
does not have to be disconnected for inflating the tires as valves for inflating the
tire are located on the wheel modules.
ending on wear situation, a replacement of the PA tube is recommended after Dep
1,000,000 km.
Various types of PA tubes are illustrated in the chart:
Order Number Figure Order Number Figure
960 731 800 0 960 731 810 0
960 731 801 0 960 731 811 0
960 731 802 0 960 731 812 0
960 731 803 0 960 731 816 0
960 731 804 0 960 731 822 0
960 731 808 0 960 731 827 0
Ta nnecting tube ble: 4-3: Co
e ently for damages and replace them if necessary.
nnections with PA tubes. At the same time, install a new
e see chapter 7.5 "Replacing wheel module I with wheel mod-
.
Ch ck PA tubes frequ
Repl
wh
ace defective hose co
el module type II,
ule II", page
43
ease notes of the manufacturer.
Vehicles with OE equipment
Rubber hoses can be fitted in vehicles installed with OE equipment. Before replac-
ing the hoses, observe the rel
Valve extension
Do not use valve extensions made of plastic
Do not use plastic valve extensions. These will not remain tight under permanently
existing pressure.