W Box 0E-A100, Руководство пользователя

Страница: 12 / 36

12
Once installed and setup, the 0E-A100 doesn’t typically need a whole lot of attention. In
the event that some adjustments need to be made, please use the following instructions.
ON/OFF
The 0E-A100 is audio-sensing, so typically once the system is installed and setup, the
power will automatically turn ON with the presence of an audio signal on either of the
L & R Line Inputs. The amp will automatically turn OFF when no audio signal has
been detected for 15 minutes.
TRIGGER - If you are using the Trigger IN, the amp will automatically turn ON when
DC voltage is applied to the Trigger jack and turn OFF when DC voltage is removed..
POWER - To manually turn the amp ON/OFF, toggle the Power ON/OFF button to
turn the amp ON/OFF.
VOLUME - Adjust the volume to the subwoofer until low frequency level has a smooth,
natural sounding transition from the left and right speakers low-midrange output.
PHASE - The Phase setting allows compensation for subwoofer location relative to the
main speakers. Adjust the Phase setting to the point of highest sub audio output.
RANGE: 0º to 180º.
CROSSOVER - The Crossover sets the frequency at which audio content will pass to
the
0E-A100 Speaker Out. Adjust the crossover so there is a slight overlap with the low-
midrange cut-off to produce a natural sounding transition to low frequencies.
RANGE: 40 Hz to 160 Hz.
BOOST-
Set to 0 dB for normal signal. Set to 6 dB for 6 dB boost @ 40 Hz.
Operation