10
Situations
Positions
When the Cat 5e/6 cable is in the
range of 30 to 40 meters.
Set positions 4 through 7
Reserved
Positions 8 through F
Adjusting the EQ Value
By default, the EQ DIP switch is in the "4" position, allowing you to use a Cat 5e/6 cable in
the range of 10 meters to 30 meters. Through this switch, you can adjust the desired EQ
value based on the actual cable length, obtaining a better viewing experience. If your
Cat 5e/6 cable is 20 meters long, follow the instructions below to adjust the EQ value.
1. Ensure that the display is powered on and connected to the receiver.
2. Ensure that transmitter and receiver are properly connected to each other, and that
their status LEDs are both solid on.
3. Locate the EQ DIP switch (outlined in the figure above) in the receiver panel.
4. Move the switch to cycle through positions 2 to 6.
