W Audio DMIX10FX, Руководство пользователя

Страница: 11 / 16

11
Identification:
20, POWER LED
LED lights up when the Mixer is turned on.
21, SIGNAL AND CLIP LED
The 4-segment level indicator displays the signal level. The CLIP LED´s illuminate when the output
signal is driven too high, which could cause distortion. If this happens, use the MAIN LEVEL control
to reduce the main level until the LED does not light anymore.
22, FX
The FX SEND controls of the stereo channels function similar to those of the mono channels.
However, since the FX send buses are both mono, a mono sum is a first taken from the stereo
input before it is sent to the FX bus.
23, FX SEND CONNECTOR
The FX SEND connector outputs the signal you choose from each individual channel using the FX
SEND controls. You can connect this to the input of an external effects device order to process the
FX bus master signal. Once an effects mix is created, the processed signal can then be routed from
the effects devices outputs back into a STEREO LINE INPUT or the STEREO AUX RETURN (only
DMIX6).
24, STEREO AUX RETURN (ONLY DMIX6)
The STEREO AUX RETURN connectors are used to bring the output of the external effects device
(whose input is derived from the aux sends) back into the console. You can instead use these
connectors as additional inputs, but any effects device will then have to be brought back into the
console via a normal stereo channel. This does, however, give you the ability to use the channel
EQ on the effects return signal if you wish.
-When you are using a stereo channel as effects return path, the FX control of the relevant channel
should generally be turned fully down to avoid undesirable feedback.
25, STEREO AUX RETURN CONTROL (ONLY DMIX6)
Use the AUX RETURN control to determine how much of the effects signal is sent to the main mix.
If only the left connector is used, the AUX RETURN automatically operates in mono.
26, CONTROL ROOM OUT
The unbalanced CTRL ROOM OUT connector carry the summed effects and main mix signals.
The PHONE/CONTROL ROOM control adjusts the level of both headphones and CONTROL
ROOM OUTPUTS.
27, FX TO CTRL
If you want to monitor only the FX send signal in your headphones or monitor speaker(s), press the
FX TO CONTROL ROOM switch.
28, LOW CUT
In addition, the mono channels are equipped with a steep LOW CUT filter designed to eliminate
unwanted low frequency signal components. These can be noise created by hand-held
microphones, subsonic noise or plosive sounds created by highly sensitive microphones.