W Audio DMIX10FX, Руководство пользователя

Страница: 10 / 16

Identification:
11, MAIN OUT
The MAIN OUT connectors are unbalanced mono connectors.
12, CD / TAPE
INPUT
The CD/MP3/TAPE INPUTS are used to bring an external signal source (e.g. CD player, tape deck,
etc.) into the console. They can also be used as a standard stereo line input.
OUTPUT
These Phono connectors are wired parallel with the MAIN OUT. Connect the inputs of a computer
sound card o ra recorder here. The output signal level is setup using the highly accurate MAIN MIX
fader.
13, PHONES
6.35mm stereo jack for headphones.
14, PHONES LEVEL
CONTROL ROOM LEVEL (EXCEPT DMIX5)
Use the PHONES / CONTROL ROOM level to adjust the signal level of the PHONES / CONTROL
ROOM output
15, MAIN MIX LEVEL
Use the MAIN MIX level control to adjust the signal level of the MAIN MIX outputs.
16, PHANTOM POWER
Phantom power is required to operate condenser microphones and is activated using the
PHANTOM POWER switch. (only available for XLR-Mic input)
17, +48V PHANTOM POWER LED
The +48V LED lights up when phantom power is turned on.
• Caution! You must never use unbalanced XLR connectors on the MIC input connectors if you
want to use the phantom power supply. All connections must be balanced using pins 1-1, 2-2 and
3-3 straight wired.
• Please do not connect microphones to the mixer (or the stagebox/wallbox) as long as the phantom
power supply in switched on. Connect the microphones before you switch on the power supply. In
addition, the monitor/PA loudspeakers should be muted before you activate the phantom power
supply. After switching on, wait approx. one minute in order to allow system to stabilise.
18, CD/TAPE TO PHONES
CD/TAPE TO CONTROL ROOM (EXCEPT DMIX5)
Press the CD/TAPE TO PHONES / CONTROL ROOM switch if you want to monitor the 2-track input
via the PHONES OUTPUT and CONTROL ROOM OUTPUT.
19, CD/TAPE TO MIX
Press the CD/TAPE TO MIX switch if you want to monitor the 2-track input via the MIX OUTPUT.
10