Vytronix JETW1800, Инструкция по эксплуатации

Страница: 8 / 12

6
Push the lance into the trigger gun
When inserted turn it. Caution: Make sure
the lance is properly fixed to the gun
Attach the nozzles. Caution: When
attaching the nozzle the button (A) on the
nozzle should come out again. Check
before activating the trigger that the
nozzle is properly fixed.
Use a reinforced hose (not supplied) with a
standard connection (ext. diameter:
16mm/int. 12mm, maximum length: 25m).
IMPORTANT! Only use water without
any impurities. If there is a risk of sand
particles in the inlet water an additional
filter should be mounted.
Let the water run through the water hose
before connecting it to the machine to
prevent sand and dirt from penetrating the
machine. Note: Check that the filter is
fitted in the water inlet pipe and that it is
not clogged up.
Connect the water hose to the water supply
by means of the quick connector (inlet
water, max. pressure: 10 bar, max.
temperature: 60°C).
Turn on the water.
The trigger gun (1) and lance is affected by
a thrust during operation - therefore always
hold it firmly with both hands.
IMPORTANT: Point the nozzle at the
ground.
Check that the machine is in upright
position. NOTE: Do not place the appliance
on uneven ground.
Release the trigger lock.
Activate the trigger of the trigger gun (1)
and let the water run until all air has
escaped from the water hose.
Press the Start/stop switch (5).
Activate the trigger of the trigger gun (1).
Always adjust the distance and thus the
pressure of the nozzle to the surface, which
is to be cleaned.
Do not cover the machine during operation
or use it in a room without adequate
ventilation.
NOTE: If the machine is left or not used
for 5 minutes, it must be switched off on
the start/stop switch (5) "O":
Press the start/stop switch (5) "O".
Disconnect the electrical plug (9) from
the socket.
Shut off the water supply and activate
the trigger of the trigger gun (1) to
relieve the machine of pressure.
Lock the trigger gun (1)
When releasing the trigger of the trigger
gun (1), the machine automatically stops.
The machine will start again when you re-
activate the trigger gun (1)
Mounting of lance and nozzle
Water connection
Start/stop
1
2
A
3