Page 7 of 12
Operation
1)
Fill the water tank
Method one:
Open the water tank cap by tuning it counterclockwise, fill
tank with 300ML of water use measuring cup, then
replace cap and turn clockwise to close.
Method two
：
Remove the water tank from main body, open the
water tank cap by tuning it counterclockwise, fill
the water tank directly from a tap, then replace cap and
turn clockwise to close.
Place the water tank back into main body until it clicks into
place.
2)
If using detergent, open the cap of the detergent tank and add the detergent into
the tank.
3)
Plug in the appliance.
4)
When the steamer is switched on, the indicator lights will turn red either side of
water tank to indicate it is preheating. If the lights do not illuminate, please check
the "troubleshooting" section for more details.
5)
It will take approximately 20 seconds for the steamer to preheat, once the steam
mop is ready to use, the water tank will glow blue and the mop will emit steam
automatically, for this reason it is important not to leave the steamer unattended
while it is pre-heating.
6)
To activate the detergent function, you will need to press the on/off button situated
on the base, when on, detergent will automatically me mixed into the steam as it is
emitted.
7)
A full tank of water should last approximately 20 minutes.
8)
The steam flow rate can be adjusted by turning the steam dial on the main body to
increase or decrease steam intensity depending on the nature of the cleaning task.
