Vykon JACE-700, Инструкция по установке

Страница: 5 / 36

PRODUCT DESCRIPTION May 2, 2011
Packaging and Features
|
JACE-700 MOUNTING AND WIRING GUIDE Part Number 11694 Rev 1.6
5
Product Description
The JACE-700 controller is a compact embedded processor platform using on-board
Flash memory for backup, in an expandable DIN-modular package. Designed for use
in commercial environments, the controller runs the NiagaraAX Framework to
provide integrated control, supervision, and network management solutions for wide
variety of networked field devices. NiagaraAX-3.5 or later is required.
Packaging and Features
The JACE-700 features a DIN-mount controller base with mounting tabs for
alternate panel mount. Two available comm option card slots are accessed under the
controller’s removable cover.
Figure 1 and Figure 2 show locations of important features of the controller.
Figure 1 JACE-700 Cover removed with 2 options installed on main board.
Typical installation requires an NPB-PWR-UN universal power supply module
(furnishing 15Vdc) for power, attaching to the controller’s left side. An RS-485 port is
on the controller’s opposite right end connector, along with 15Vdc power for support
of I/O expansion modules, either chained directly and/or wired remotely.
Note Instead of using the NPB-PWR-UN power supply module, you can adapt
an WPM-
XXX wall mount AC power adapter to power the controller.
However, you cannot directly attach I/O expansion modules in this
configuration, nor power remote I/O modules from that WPM-
XXX .
Removable cover
Status and heartbeat LEDs
Option card #2 area
(card shown installed)
Option card #1 area
(card shown installed)
Connector for NPB-PWR-UN
power supply module
NiMH backup
battery pack
RS-485, 15V Power
Output Connector
Connector ports