VYKING FORCE VF3600P, Инструкция по эксплуатации

Страница: 18 / 44

18
8. Check the pump is primed & air is purged from lines by squeezing the spray gun
trigger allowing water to flow through the pump. YOU WILL DAMAGE THE PUMP IF
THIS STEP IS NOT PERFORMED BEFORE STARTING THE ENGINE.
Pressure washer start up
!
WARNING
Before starting up the pressure washer check
that it is receiving water correctly; use of the
appliance without water will damage it. Do not
cover the ventilation grilles when the pressure
washer is in use.
Running the pump dry will cause damage and
void the warranty.
1. Turn on the water supply tap fully.
2. Release the safety catch on the gun
3. Squeeze the gun trigger to purge the air for a few seconds and start the engine
according to the operating instructions of the engine manufacturer.
Engine start up
!
WARNING
During operation the pressure washer must be
positioned on a firm, stable surface.
Start the engine and follow all safety precautions according to the operating instructions
of the engine section in this manual.
Recommended cleaning procedure
1. Hold the spray gun firmly with two hands and a sturdy stance -- Gun kicks back when
triggered.
2. Dissolve dirt by applying the detergent mixed with water to the surface while still dry.
When dealing with vertical surfaces work from the bottom upwards.
3. Leave the detergent to act for 1-2 minutes but do not allow the surface to dry. Starting
from the bottom, use the high pressure jet at a minimum distance of 30 cm. Do not
allow the rinse water to run onto unwashed surfaces.
4. In some cases, scrubbing with brushes is needed to remove dirt. High pressure is not
always the best solution for good cleaning results, since it may damage some
surfaces. The finest adjustable nozzle jet should not be used on delicate or painted
parts, or on pressurised components (e.g. tyres, inflation valves, etc.).