Vyaire VELA, Руководство по обслуживанию

Страница: 53 / 111

5-16
Chapter 5: One-Year P.M. Procedure
33373-001 Version A
8. Remove the four ¼ spacer nuts on the battery tray; set them aside (Figure 5-25).
Figure 5-25. Spacer Nut Location
9. Locate the new battery tray, P/N 16048.
10. Place the four ¼ spacer nuts onto the new battery tray and secure.
11. Place the capacitor onto the new tray and secure the two capacitor straps with the previously
removed four ¼ nuts and star washers.
12. Connect the wire harness onto the capacitor as follows:

White wires to positive terminal on the capacitor

Black wires to the negative terminal on the capacitor
13. Secure harness on the terminals with the flathead screws.
14. Place the black covers over the terminals.
15. Locate the previously removed ribbon cable and ferrite chokes.
16. Secure the ribbon cable and two ferrite chokes to the battery tray with the previously removed ¼
nuts. Make sure the cable does not kink or bind on the capacitor straps.
17. Reconnect the Molex connector from the battery tray to the Main Wiring Harness.
18. Place the battery tray back onto the top of the ventilator.
19. Reconnect the ribbon cable to the Main PCB and the Peripheral PCB.
20. Replace the top cover.
21. Perform the OVP per the directions in Chapter 7.