www.vxitech.com
CT-100C Installation
23
R
ACKMOUNT
O
PTION
I
NSTALLATION
O
VERVIEW
This section contains the procedures for installing a CT-100C chassis in a standard 19” relay rack.
The available rackmounting options are:
Option 59 – Rackmount Ear Kit
Option 60 – Rackmount Door Kit
Option 63 – 20” Slide Kit
Option 64 – 24” Slide Kit
Option 65 – Acrylic Rackmount Door Kit
The rackmount ear kit provides the basic hardware necessary to rackmount the CT-100C chassis
and must be purchased to install any other rackmounting options. Because the chassis is only 15”
wide, standard rack support rails cannot provide mechanical support to the chassis. If the
equipment mounted below the CT-100C cannot provide mechanical support to the chassis, either
20” or 24” slides will be required to support the chassis in the rack. The rackmounting ears are
designed to allow the chassis to be flush mounted in the rack or recessed 4”.
The rackmount door kit provides the necessary hardware to install either a 1/8” thick aluminum
door or a 1/8” thick acrylic door in front of the rackmounted chassis. These options require that the
rackmount ear kit also be installed and configured for recessed mounting. The door may be
customer modified to hold connectors, controls, indicators, and similar components.
The 20” and 24” slide kits provide the ability to easily remove the chassis from the rack for
servicing and provides mechanical support for the chassis when installed in the rack. The 20” slide
kit is used when the chassis is flush mounted in the rack. If the chassis is to be recess mounted,
then the 24” slides are required.