Adjust display brightness
Adjust display contrast
Select display mode
Adjust display backlight brightness
Reset display settings to factory defaults
Exit OSD
Display Modes
Your video eyewear is capable of displaying stereoscopic 3D images in
two ways. If the video content is enabled with iWear 3D control
information, it will automatically be displayed in the proper 3D mode. If
your 3D content does not contain iWear 3D control information, use the
OSD controls to select the correct display mode.
Select & Adjust Display Mode:
Access the OSD by pressing and holding down the Control
Wheel for more than 3 seconds. With the OSD visible, rotate the
Control Wheel to select the Display Mode options icon.
With the Display Mode command selected, rotate the Control Wheel to
select one of the display modes. Press and release the Control Wheel to
make your selection.
2D display mode
L/R display mode
R/L display mode
Use the 2D display mode for all monoscopic (2D) video content.
There is no standard for videos using L/R or R/L mode for 3D video. The
easiest method of determining which is used for any given video is too
simply to try one and if the 3D quality is not as expected, switch to the
other.
