1
OVERVIEW
The Vutec Table Lifts are designed for raising and retracting light loaded projectors such as
LCD or DLP type projectors. The mechanism is shipped complete and ready to be installed
inside a custom-made cabinet. No assembly is required except for simple leveling adjustments
once installed. The lift comes with RF remote control system as standard package.
It is important to remember that the total weight of the cabinet cover and the projector must not
exceed the specified maximum lifting capacity. The specification sheet is provided with this
manual.
Following are the primary steps involved in the planning and completion of a standard
installation.
MECHANICAL INSTALLATION
Referring to the specification sheet, determine the size and shape for the cabinet to be built to
enclose the lift. It is recommended that measurements should be taken off the actual lift for exact
fit.
The space for the projector to occupy is in the form of a rectangular; thus, depending on the
projector size and shape; the projector lens may be aiming along the length or the width of the
rectangular space. Figures 1a and 1b demonstrated these two scenarios. Access doors for lift’s
internal components should be provided and the doors should always on the backside of the
projector. Two doors center closing is recommended for minimum swing out.
