Fig. 21
16. Install burner support rails on replacement
burner.
17. Reverse procedure to install.
18. Perform CERAMIC-RADIANT BURNER AIR
INFRARED BURNER
Shut off the gas before servicing the
unit.
1.
2.
Adjust rack assembly to the lowest position.
3.
From inside the broiler cooking area, remove
wire Fig. 22 securing burner to mounting bracket.
Fig. 22
4.
Lift burner up at the rear and slide it away from
gas orifice to remove from broiler.
5.
Reverse procedure to install replacement burner.
NOTE:
When installing, secure the burner with wire.
6.
Check for proper operation.
GAS PRESSURE REGULATOR
Shut off the gas before servicing the
unit.
All gas joints disturbed during
servicing must be checked for leaks. Check with a
soap and water solution (bubbles). Do not use an open
flame.
Clean pipe threads and apply thread
sealant that is suitable for use with propane gases.
NOTE:
Gas pressure regulator should be installed as
close to the broiler inlet gas connection as possible.
1.
Thread regulator [1] Fig. 23 onto pipe hand tight
with arrow on regulator pointing in direction of
gas flow to the broiler.
Fig. 23
2.
Tighten regulator securely in horizontal position
with the regulator adjustment upward [2] Fig.
23. Regulator adjustment is below the closing
nut.
NOTE:
Regulator will not function properly without
adjustment screw pointing upward.
3.
Connect main gas supply line to gas pressure
regulator inlet.
4.
Adjust regulator as outlined in REGULATOR
ADJUSTMENT.
RACK SPRINGS
NOTE:
Springs should be replaced in pairs for proper
operation of the rack lift assembly.
1.
Raise the rack lift assembly to its highest position
on stop bracket to relieve spring tension.
V-SERIES HEAVY DUTY BROILERS, DOUBLE DECK AND RANGE MATCH MODELS - REMOVAL AND
REPLACEMENT OF PARTS
F45548 (0715)
Page 10 of 16
