REMOVAL AND REPLACEMENT OF PARTS
MANIFOLD COVER
1.
Remove screws that secure manifold cover and
remove the cover from broiler.
2.
Reverse procedure to install.
Fig. 1
CONTROL VALVE COVER
Shut off the gas before servicing the
unit.
All gas joints disturbed during
servicing must be checked for leaks. Check with a
soap and water solution (bubbles). Do not use an open
flame.
1.
NOTE:
When servicing the upper broiler on a double
deck unit, the manifold cover on the lower broiler must
also be removed.
2.
Loosen set screw and remove knob from control
valve.
Fig. 2
3.
Remove screws securing the control valve cover
[1] to broiler.
Fig. 3
4.
Reverse procedure to install.
CONTROL VALVE
Shut off the gas before servicing the
unit.
All gas joints disturbed during
servicing must be checked for leaks. Check with a
soap and water solution (bubbles). Do not use an open
flame.
Accessing Control Valve
•
Upper Broiler (double stack or single unit over
range) - The side panel must be removed as
outlined in the procedure. The rear of panel is
secured to the broiler frame with screws. The
bottom lip of the panel and the top lip of the panel
at the both corners are an interference fit.
•
Lower Broiler (double stack or finishing oven on
top) - The side panel can only be pulled away
from broiler at the bottom of panel. The rear of
panel is secured to broiler frame with screws. The
bottom lip of the panel at the front and rear are
an interference fit. The top lip of the panel is
secured to the broiler frame with screws.
NOTE:
When servicing the upper broiler on a double
deck unit, the manifold cover on the lower broiler must
also be removed.
V-SERIES HEAVY DUTY BROILERS, DOUBLE DECK AND RANGE MATCH MODELS - REMOVAL AND
REPLACEMENT OF PARTS
Page 5 of 16
F45548 (0715)
