Vulcan-Hart RGT-10, Инструкция по установке, обслуживанию и запасным частям

Страница: 4 / 26

VULCAN RGT-10 GAS CONVECTION OVEN
INSTALLATION, SERVICE & PARTS MANUAL – INDEX
Your Vulcan RGT-10 Gas Convention Oven is the finest
made. Proper use and maintenance will result in many
years of satisfactory performance.
We suggest that you carefully read this entire manual and
carefully follow all of the instructions.
DESCRIPTION PAGE
DEFINITIONS (Inside Front Cover)
CAUTIONS 1
INDEX 2
SECTION I (INSTALLATION)
INSTALLATION INSTRUCTIONS 3-4
SECTION II (SERVICING)
GENERAL THEORY OF OPERATION 5
PARTS REPLACEMENT 6-10
TROUBLE SHOOTING 10-11
COOKING CHART 12-13
SECTION III PARTS
PARTS LIST 14-24
REVISION PAGE (Inside Back Cover)
RGT-10 units are supplied with a 7 foot 3 wire supply
cord. Appliances are equipped with a three prong
(grounded) plug for your protection against shock hazard
and should be plugged directly into a properly grounded
three prong receptacle. DO NOT cut or remove the
grounding prong from this plug.
For installation on combustible floors with minimum
clearances from combustible construction, 0 in. at the
sides and 6 in. at the rear.
A rating plate is located on the lower panel stating the
model number, type gas, serial number, voltage and
amperage.
A wiring decal is also located on the lower front panel.
Motor blowers in the RGT-10 units are permanently
lubricated and require no additional lubricating main-
tenance.
2