Vulcan Concept VMG601, Руководство по эксплуатации

Страница: 9 / 48

9
damage plastic parts of the device. Be careful to avoid penetration of
water inside the machine body.
Keep the cutting accessories sharp and clean.
TRANSPORT:
The device should be transported and stored in a package that protects
the tool from moisture, penetration of dust and fine particles. In
particular it is necessary to protect the ventilation openings. Fine
particles that can get into the device housing may damage the motor.
ENVIRONMENTAL PROTECTION :
NOTE : The symbol nearby denotes that old equipment must
never be disposed together with other wastes (with the
penalty of a fine). Hazardous components of electronic
equipment may adversely affect the natural environment and
human health.
Each household may contribute to recovery and reuse (recycling) of old
machinery and equipment. Both in Poland and Europe a system for
recovery of used equipment either exists or is being developed. The
system obliges all organizations that sell such equipment to collect back
the used machinery and appliances. Moreover, general purpose
collecting points for such equipment are also available
.
MANUFACTURER:
PROFIX Ltd., 34 Marywilska Street, 03-228 Warsaw, POLAND.
This appliance is in conformity with national and European standards as
well as with general safety guidelines.
NOTE: Any repairs are allowed to be carried out exclusively by qualified
staff with use of original spare parts.
PICTOGRAMS:
Explanation of the icons located on the nominal plate and the
information tags
:
TROUBLESHOOTING GUIDE:
PROBLEM POSSIBLE CAUSE REMEDY
Irregularities of the motor
operation.
Worn carbon brushes of the motor
The tool (plane r ) fails
to operate .
No power voltage, damaged
motor or the power trigger.
Check whether the power cord is connected correctly and check fuses. When
the problem persists hand over the tool for repair at a service workshop. Please
refer to the warranty sheet for addresses of authorized workshops.
Have the brushes replaced at a service workshop.
The cutting roller fails
to rotate The transmission V-belt is worn/
damaged
Replace the V-belt (see: « » Replacement of a transmission belt
«Always wear appropriate eye protection»
«Use appropriate hearing protection»
«Read this instruction before switching on the
power supply and starting the work»
«Always wear the anti-dust mask»
The policy of the PROFIX company consists in permanent improvements of the offered products and therefore the company
reserves the right to make amendments to the product specification without a prior notice. The images included into the
operation manual are only of the exemplary nature and may slightly differ from actual appearance of the device
purchased.
This
instruction manual is protected by copyright. Copying it without the written consent of PROFIX Co. Ltd. is prohibited.