10
The Wall Mount adaptor is designed to
fit on standard Wall Mount plates.
1. Choose a spot near an electrical
outlet and a telephone jack. Your
phone requires a modular tele-
phone jack and a standard electri-
cal outlet (120V AC). The power
cord is six feet long; make sure there
is an electrical outlet within reach of
the base. The outlet should not be
controlled by a wall switch. If the
switch is ever turned off, the phone
will not operate.
2. Position the wall mount adapter on
the base. Line up the tabs on the
wall mount adapter with the holes
on the bottom of the base. Snap the
wall mount adapter firmly in place.
3. Mount the base on the wall. Posi-
tion the base so the mounting studs
will fit into the holes on the bottom
of the base. Position the power cord
to extend down the wall the phone
is to be mounted on. Slide the base
down on the mounting studs until it
locks into place.
4. Connect the telephone cord. The
telephone line cord has a snap-in
plug at each end. Insert one of the
plugs into the jack on the bottom of
the base. Insert the other end of the
plug into the wall jack.
5. Connect the power cord. Plug the
DC connector into the DC jack at
the rear of the base unit. Plug the
AC power adaptor into an electrical
outlet.
WALL MOUNTING
wallboard
wooden
stud
RINGER LEVEL
OFF
HIGH
LOW
DIAL MODE
PULSE
T
ONE
