The telephone is now ready for connection to the telephone
network.
HANDSET BATTERY PACK:
Before using your VT650 telephone, the handset battery pack has to
be installed and fully charged. The base station must be connected
to the mains electricity supply using the power adapter.
INSTALLING THE HANDSET BATTERY PACK:
Install the battery pack, first connect the plug on the lead to the
socket and lay the battery as per diagram, fit the battery
compartment door. Use only a VTech approved rechargeable
battery pack. Failure to do so could result in batteries exploding
whilst being charged and void the warranty.
CHARGING THE HANDSET:
Place the handset on the base and leave until the handset battery
pack is fully charged (at least 12 hours). The charge LED on the base
will light up whilst the handset is on base.
WARNING:
Your base must be connected to the electricity supply at ALL
times, except when the product is not to be used for long
periods of time.
Inserting Batteries and Charging Handset
10
BATTERY LOW WARNING:
When the phone is in standby mode, if you see the in use LED
flashing, it means that the battery is low and you need to replace
your handset on the base station to recharge.
• When the phone is off the hook, if the battery is low, you will
hear battery low warning tone every 2 seconds. The line will
disconnect after 90 seconds.
• When there is an incoming call, it will have a warning beep every
2 seconds the line will disconnect after 90 seconds.
INSTALLING BATTERY PACK:
OUT OF RANGE WARNING:
When handset moved beyond operation range, an out of range
warning tone will sound. Handset and base station will on hook
automatically after 20 seconds if out of range condition persists.
11
Battery Pack
VT650 User Guide A/W 30/5/02 2:07 pm Page 11
