56
57
*
Your base unit and handset may not be operating on the same channel or
security code. Place the handset in the cradle for a few moments to reload
the security code and reset the channel.
COMMON CURE FOR ELECTRONIC EQUIPMENT
Electronics, like people, can sometimes get confused. If the unit does not seem to
be responding normally, then try putting the handset in the cradle to re-
initialize the unit. If it still does not seem to respond, perform the following
steps (in the order listed):
1.
Disconnect the power to the base.
2.
Disconnect (remove) the handset battery.
3.
Remove the base unit battery pack, where applicable.
4.
Wait a few minutes.
5.
Connect power to the base.
6.
Install the handset battery pack.
7.
Put the handset in the base to re-initialize. If the handset has not been
recently charged, allow 8 hours before use.
•
You may be out of range. Either move close to the base, or relocate the base
unit.
•
The layout of your home may be limiting the range. Try moving the base unit
to the second or third floor, or to some other location.
THE HANDSET DOES NOT RING WHEN YOU RECEIVE A CALL.
*
Ensure that the ringer is turned on.
*
Make sure the telephone line cord is plugged firmly into the base unit and
the telephone jack. Make sure the power cord is plugged in.
*
You may be too far from the base unit.
*
You may have too many extension phones on your telephone line to allow
all of them to ring. Try unplugging some of the other phones.
THE BASE DOES NOT RING
*
Make sure the BASE RINGER switch is not set to off.
*
There may be too many extension phones on your line. Try unplugging one
of the other phones.
YOUR CALLER FADES IN AND OUT.
*
You may be nearly out of range. Move closer, or relocate the base.
YOU HEAR OTHER CALLS WHILE USING YOUR PHONE.
*
Replace the handset in the base cradle, wait a few moments and try again.
*
Disconnect your base unit from the telephone jack, and plug in a regular
telephone. If you still hear other calls, the problem is probably in your wiring
or local service. Call your local telephone company.
YOU HEAR NOISE IN THE HANDSET, AND NONE OF THE KEYS OR BUTTONS
WORK.
*
Make sure the power cord is plugged in.
Содержание VT 9171
Страница 33: ...64 65 ...
Страница 34: ...66 67 ...