9
Registration
Enable Repeater Mode on the SIP DECT Base Station:
Follow the instructions below to enable your VTech ErisTerminal SIP DECT Base
Station to connect to the VSP605 Range Extender.
1. Open the Web User Interface (WebUI) for the SIP DECT Base Station.
2. Go to the
System
>
Repeater
Mode page.
3. Select the
Enable Repeater Mode
checkbox, and then click
Save
.
NOTE:
Changing this setting will reboot your SIP DECT Base Station.
Register the Range Extender to the SIP DECT Base Station:
Follow the instructions below to register the VSP605 Range Extender to your
VTech ErisTerminal SIP DECT Base Station.
Make sure the Range Extender is not connected to AC power before registering.
You can register up to five Range Extenders per Base Station.
1. Set the Base Station into registration mode: press the HANDSET LOCATOR
button for at least four seconds, and then release the button. Both LEDs on the
base station begin to flash.
2. Use the AC adapter to connect the Range Extender to an electrical socket.
3. Press and hold the button for 5 seconds. The Range Extender will start the
registration to the Base Station.
NOTE:
The registration mode of the Range Extender may last for 30 minutes.
Connect a Range Extender to another Range Extender in Cascade Mode:
You can connect up to two Range Extenders in series between a VTech ErisTerminal
SIP DECT Base Station and Handset. This connection is called Cascade Mode.
Follow the instructions below to connect two VSP605 Range Extenders in
Cascade Mode.
1. Register all of your Range Extenders to the Base Station (as described in
“Register the Range Extender to the SIP DECT Base Station”
, above).
2. Take one of the Range Extenders to a location where it is far enough away
from the Base Station, but close to a Range Extender to get a Cascade Mode
connection.
3. Use the AC adapter to connect the Range Extender to an electrical socket.