31
Appendix
I have
manually or
accidentally
deregistered
my headset
from the
Dongle.
The VH6212 headset comes pre-registered to the
Dongle. If, for some reason, the headset is not
registered to the Dongle, follow the instructions below
to register your headset to the Dongle.
1. Make sure the battery is properly installed in the
headset. The headset
LED
light flashes slowly
in red and blue to indicate the headset is not
registered.
2. Place the headset in the charger cradle and allow
it to charge for at least one hour before beginning
registration.
3. Remove the headset from the charger cradle.
4. Press and hold the pair button on the Dongle for
about four seconds until the Dongle LED light on
flashes red very quickly, and then release the button.
5. Return the headset to the charger cradle for
registration. The headset
LED
light alternates
quickly in red and blue.
It takes about 60 seconds to complete the registration
process. Once the headset is registered, the headset
LED
light turns red when the battery is low and
being charged, or turns purple when the battery is well
charged, or turns blue when the battery is fully charged.
If the registration fails, you hear the voice prompt
“Not registered”
when you press the headset
ON/OFF
button on the headset, and the headset
ON/OFF
button light on the headset alternates slowly in
red and blue.
Troubleshooting