19
Appendix
Adding and registering a new headset
Option 2: Register a headset to a VU-060 dongle
1. Make sure the battery is properly installed in the headset (see
page 4). The
LED
light flashes slowly in red and blue to
indicate the headset is not registered.
2. Place the headset in the charger cradle and allow it to charge for
at least one hour before beginning registration.
3. Remove the headset from the charger cradle.
4. Press and hold the pair button on the Dongle for about four
seconds until the Dongle LED light on flashes blue slowly, and
then release the button.
5. Return the headset to the charger cradle for registration. The
LED
light alternates quickly in red and blue.
It takes about 60 seconds to complete the registration process.
Once the headset is registered, The
LED
light turns red when the
battery is low and being charged, or turns purple when the battery
is well charged, or turns blue when the battery is fully charged.
If the registration fails, you hear the voice prompt
"Not registered"
when you press the
ON/OFF
button on the headset, and the
ON/OFF
button light on the headset alternates slowly in red and
blue. Try the registration process again.
NOTE:
• You cannot register a headset if another system headset is in use.
