18
Appendix
Adding and registering a new headset
Option 1: Register a headset to your VH6210/VH6211 headset base
1. Make sure the battery is properly installed in
the headset. The
LED
light flashes slowly
in red and blue to indicate the headset is not
registered.
2. Place the headset in the headset base and
allow it to charge for at least one hour before
beginning registration.
3. Remove the headset from the headset base.
4. Press and hold the
PAIR
button for about four
seconds until the
PHONE
light on the headset
base turns on, and then release the button.
5. Return the headset to the headset base for
registration. The
LED
light alternates quickly
in red and blue.
It takes about 60 seconds to complete the
registration process. Once the headset is
registered, The
LED
light turns red when the
battery is low and being charged, or turns purple
when the battery is well charged, or turns blue
when the battery is fully charged.
If the registration fails, you hear the voice prompt
"Not registered"
when you press the
ON/OFF
button on the headset, and the
ON/OFF
button light on the headset alternates slowly in red and
blue. Try the registration process again.
NOTE:
• You cannot register a headset if another system headset is in use.
