Connecting power to Base Unit
Plug the AC power adapter into an electrical outlet, and the DC connector into the
bottom of the Base Unit.
Setup
MODEL: 2418
DC 9V 200mA
CLASS 2 POWER SOURCE ONLY
CORDLESS TELEPHONE
HAC
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT
TO THE FOLLOWING TWO CONDITIONS: 1)THIS DEVICE MAY NOT CAUSE HARMFUL
INTERFERENCE; AND 2)THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED,
INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. PRIVACY OF
COMMUNICATIONS MAY NOT BE ENSURED WHEN USING THIS PHONE.
COMPLIES WITH 47 CFR Part 68
FCC REGISTRATION NO.: US:xxxxxxx
RINGER EQUIVALENCE: xx
USOC JACK: RJ11C,RJ11W
MODEL: 2418
MANUFACTURED IN CHINA
CANADA XXXXXXXXXX
REN/IES: XXX
IC: RSS/CNR XXX
FCC ID: EWXXX-XXXX-XX
TEL. LINE
9V DC
POWER
JACK
4
Getting Started
1
2
Installation of Battery Pack in Handset
Follow the steps below:
1.
Remove the battery cover by pressing
on the indent and sliding downward.
2.
Place the new battery pack in the
Handset with the metal contacts aligned
with the charge contacts in the battery
compartment.
3.
Replace the battery cover by sliding it
upwards.
4.
If the new battery pack is not already
charged, place the Handset in the Base
Unit, and allow it to charge for 12 hours.
After the initial charge, a maintenance
charge of 8 hours should be sufficient.
