19
Wall mounting the charger
The charger is ready for tabletop use. If you want to mount the charger on a wall,
use two 10 mm (7/16 inch) screws and wall anchors (not provided) to hold the
charger in place. Screws and wall anchors are not provided, but are available
for purchase at hardware retailers. You might need a professional to install the
charger.
To mount the charger on the wall:
1. Use a pencil to mark the desired positions of the two holes on the wall. Make
sure the space between the two holes is 30 mm. Drill two holes in the wall
according to the marks.
2. If you drill the holes into a stud, go to step 3.
-OR-
If you drill the holes into an object other than
a stud, insert the wall anchors (not provided)
into the holes and tap gently on the ends with a
hammer until the wall anchors are flush with the
wall.
3. Insert the screws (not provided) into the holes
and tighten them until only 1/4 inch of the screws
are exposed.
4. Align the holes at the back of the charger with
the screws on the wall and slide the charger
down until it locks into place.
Screw spacing 30 mm
(1 3/16 inches)