4
Getting started
Battery charging
Once you have installed the battery, the screen indicates the battery status
(see the table below). If necessary, place the handset in the telephone base
or charger to charge the battery. For best performance, keep the handset in
the telephone base or charger when not in use. The battery is fully charged
after 16 hours of continuous charging. See the table on page 40 for battery
operating times.
If the screen is blank, you need to charge the handset without interruption for
at least 10 minutes to give the handset enough charge to use the telephone
for a short time. The handset beeps and shows
LOW BATTERY
. If you are on
a call in low battery mode, the handset beeps every minute.
The following table summarizes the battery charge indicators and actions
to take.
Battery indicators
Battery status
Action
The screen is blank.
Battery has no charge
and the handset cannot
be used.
Charge without interruption
until the screen shows
LOW BATTERY
(at least 10
minutes).
The screen shows
PLACE IN CHARGER
and
ƀCUJGU
Battery has very little
charge and the handset
cannot be used.
Charge without interruption
until the screen shows
LOW
BATTERY
(at least four
minutes).
The screen shows
LOW BATTERY
,
ƀCUJGUCPFVJG
handset beeps.
Battery has enough
charge to be used for a
short time.
Charge without interruption
until the screen shows
HANDSET X
(about one hour).
The screen shows
HANDSET X
.
Battery is charged.
To keep the battery charged,
place it in the telephone base
or charger when not in use.