Add and register a pendant
To register a pendant to your SN6127/SN6187 telephone base:
Press and hold
/FIND HANDSET
at the side of
the telephone base until the
IN USE
light turns
solid red.
Put the pendant in the pendant charger. The
pendant status light flashes red and green to
indicate the registration is in progress. The pendant
beeps. Then it is registered with the telephone
base. It takes up to 60 seconds to complete
registration.
If registration fails, you hear an error tone.
Start again from Step above.
Deregister all devices
If you want to replace a device, or reassign the designated handset
number of a registered handset, you must deregister all devices that are
registered to the telephone base. Then register each device individually.
To make deregistration easier, read all of the instructions on this and the
next page before you begin.
To deregister all devices from your SN1157/SN1197/SN6147/
SN6197 telephone base:
Press and hold
FIND HS
at the side of the
telephone base for about 0 seconds until the
telephone base shows
Registering... Please
wait
followed by
Deregister all devices?
, then
release
FIND HS
.
.
2.
.
You cannot register a pendant if any other system device is in use.
If the pendant is not registered and you press
or
VOICE
, you will hear,
“Not registered.”
•
•