Table/Desk Installation
Connecting power to base unit
Choose a spot near an electrical outlet (110V AC) and a telephone jack not
controlled by a wall switch.
Setup
4
Getting Started
Battery Installation
1.
Remove the battery cover by pressing
on the indent and sliding downward.
2.
Align the two holes of the plug with the
socket pins and insert the plug. Place
the battery in the compartment with the
wires in the lower right corner. Angle
the top of the battery under the top
claws first, then snap the battery into
place. Tuck the wires under the guide,
located below the battery.
3.
Replace the battery cover by sliding it
upward.
4.
If the new battery is not already
charged, place the handset in the base
Unit, and allow it to charge for 15 hours.
After the initial charge, a maintenance
charge of 8 hours should be sufficient.
