VSPHOENIX VSPHOENIX S, Руководство по эксплуатации

Страница: 6 / 26

VSPHOENIX S MANUAL 11
VSPHOENIX S Assembly Instructions VSPHOENIX S Assembly Instructions
10 VSPHOENIX S MANUAL
1. Be careful with camera and its support to avoid breakage.
2. After installation, please fix machine with machine foot.
3. Should be setup by 2 or more person for safety
Notice before Installation
Should be setup by 2 or more person for safety.
Required Parts
Top Bracket 1ea / Wrench Bolts 4ea(Including Washer) / LED Monitor 1ea / Monitor Cable 3M 1ea / Wooden Pannel 1ea /
AD paper 1ea / Protection Acrylic 1ea / Screw 4ea
B TYPE Assembly(Monitor on top)
1
2
Remove steel plate on the back
Remove wooden plate on the back
3
Disconnect Sensing PCB cables
4
Remove LED monitor
Separate LED monitor by loosening bolts of bracket
!
!
A TYPE Assembly(Monitor in middle)
1
4 5
8 7
1. Assemble foot step and lower part.
2
Fasten the footboard to bottom part
by using 8 of hexagonal headed bolt.
3
Make sure the 4 footsteps are horizontally
on flat surface. If you have to install the
machin on inclined plane, use paper or
plastic to make the surface horizontal level.
6
Tighten Hexa Bolts by using hex wrench. Connect cables according to Cable guide
sticker on the PC Box.
Completed assembly
of the machine.
Lift up the upper part and place it on
top of the lower part.
(Should be setup by 2 or more person)
Remove steel plate on the back.
3
Prepare the upper part and lower part
2
Hexagonal headed bolt :
8ea
1
3
4
5
6
7
8
KEY
Wrench bolt 8 X 25 (4ea)
Trust bolt THMS 4 X 8 (6ea)
※Pictures of the bolts used when dual monitor is combined.