VSpeak VSpeak for FRSky, Руководство пользователя

Страница: 14 / 16

FRSky, Version: 1.4 www.VSpeak-modell.de
Page 14/16
8.3.3
„VSpeak-Vario“
- Announcement altitude in: m / ft
- Vario sound
- Announcement acceleration X-axis in: g
- Announcement acceleration Y-axis in: g
- Announcement acceleration Z-axis in: g
- Announcement temperature 1 in: °C / °F
with connected Balancer:
- Announcement cell number with minimal voltage in: V + alarm
- Announcement cell sum voltage in: V
8.4 Smart-Port-Sensors for FrSky-S.Port
Tested have been:
8.4.1 Hub-less FrSky „Variometer Sensor“
- Announcement altitude in: m / ft
- (only pseudo-) Vario tone
By connecting the vario to the S.Port there is no information of the climb rate at the
output of the FrSky- Transmit-Modules (DHT, DFT …) The VSpeak module generates
the vario tone by a calculation based on the altitude. This is not the best way.
If you connect the vario to the receiver that supports the old telemetry port (Tx, RX
GND) the VSpeak module can get the vario value directly and can generate a better
vario tone.
8.4.2 UniSens-E from sm-modellbau
- Announcement altitude in: m / ft
- (only pseudo-) Vario tone
By connecting the vario to the S.Port there is no information of the climb rate at the
output of the FrSky- Transmit-Modules (DHT, DFT …) The VSpeak module generates
the vario tone by a calculation based on the altitude. This is not the best way.
Other FrSky-Sensors with S.Port have not been tested so far.