VSpeak Pulse Generator, Руководство пользователя

Страница: 2 / 4

Pulse Generator Version: 1.0 www.VSpeak-modell.de
Page 2/4
1 Connection
1.1 Input
The pulse generator is plugged with its servo plug either at any receiver power slot, or at the
PowerBox system at the slot designated P²-Bus, . . . or for programming:

on a JetiBox or –

using the JetiBox emulation of a Jeti DC / DS transmitter - with
ext. marked slot of the Jeti receiver
For the relevant servo channel, a 3-step switch can now be programmed in the transmitter with
the values -100% (OFF) 0% (PULSE) +100% (ON).
1.2 Output
In principle, all devices that are otherwise directly plugged into a servo slot of the receiver can
be connected to the output, the 3-pin post connector.
Attention:
The pin has the same voltage as the input, ie. When the output is not
connected, special care must be taken with regard to a short circuit.
1.3 LED Indicator
LED: green (ON)
→ servo output position ON
green (flashing) → servo output in PULSE operation, with the LED ON time
corresponding to the servo output ON duration
red (ON)
→ servo output position OFF
red (flashing)
→ only if the JetiBox is plugged in to program the ON / OFF times:
Display of the ON duration
The blue LED is blinking every second to signal the normal function of the
Pulse Generator.
blue LED
LED green/red
Servo output