IMPORTANT: Always unplug the appliance when not in use or before
cleaning. Do not leave unattended when plugged in or switched on.
Do not place on any heat sensitive surface.
• Do not use any attachments other than those supplied by Conair
Australia Pty Ltd.
• Use this appliance only for its intended use as described within
this instruction booklet.
• Always unplug the appliance when fully charged.
• This appliance is not intended for commercial use.
• Never drop or insert any object into an opening.
• Do not use the appliance with damaged or broken attachment combs
or with any teeth missing from the blades, as injury may occur.
• Do not place on any surface while it is operating.
• Do not use outdoors or operate where aerosol (spray) products
are being used or where oxygen is being administered.
• Keep the cord away from heated surfaces
• Do not use the appliance if it is damaged. In the event of damage,
discontinue use immediately and contact your dealer for instructions
on returning it for examination or exchange. If the supply cord is
damaged, it must be replaced by the manufacturer, its service agent
or similarly qualified person in order to avoid a hazard.
• Never twist or pull on the trimmer cord.
• After use do not wrap the cord around the appliance as in time
this may cause the cord to fracture. Coil cord loosely by the side
of the appliance in storage.
• Always ensure that the voltage to be used corresponds to the
voltage marked on the unit.
• For additional protection, the installation of a residual current
device (RCD) with a rated operating current not exceeding
30mA is advisable in the electrical current circuit supplying the
bathroom. Ask your installer for advice.
