CA
8- Wooden part installation
CG
WARNING ! Securely install the receiver and power pack, ensuring they will not come loose or rattle during flight.
Never fly before checking the Cg’s required position.
ELEVATOR STROKE
RUDDER STROKE
25/32”(20mm)
5/16”(8mm)
5/16”(8mm)
25/32”(20mm)
9- Balance / Schwerpunkt
Hohenruderausschlag
Seitenruderausschlag
Do not try to fly an out-of balance model!
Uberprufen Sie vor dem Flug den Schwerpunkt.
38mm
TEST GLIDING
Test glide by launching over long grass to check the trim and stability. The model should always be launched into the
wind and only fly in light wind conditions. Adjustments to the flight path can be made by slightly bending the rear edges
of the tail surfaces. Deflecting the rear edge of the tailplane down will make the model dive, bending it up will make the
nose rise (too much will make the model stall) Bending the rear of the fin will make the model turn or the wing can be
“slewed” so that it is not square to fuselage.
Correct glide
Stall - add weight
Dive - remove weight
